LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Driver Door Control System - Diagnosis) >> Circuit Inspection >> DTC B1231 Jam protection limit switch circuit on driver door >> Circuit Description

Circuit Description

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.

This DTC is output when failure of the jam protection limit switch circuit is detected.

The jam protection limit switch is built in the power window motor.

This switch is OFF when the window stays between the fully closed position and 4 mm under the full-closed position, and Driver Door ECU reads this signal.

DTC B1231 TROUBLE DETECTION

DTC No. DTC Detection Condition Trouble Area
B1231 No change in limit switch more than 2.0 seconds even if operating glass down when limit switch is OFF (window glass is fully closed)
  • Jam protection limit switch
  • Wire harness

HINT:

When the door ECU detects the condition that the power window is lowered to turn the limit switch from OFF to ON, this DTC is cleared.