LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Front Light (Body No. 5) Control System - Diagnosis) >> Circuit Inspection >> Parking Light Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check parking light using LEXUS hand-held tester. 

    PREPARATION: 

    Connect the LEXUS hand-held tester to the DLC3.

    CHECK: 

    Check the parking light using ACTIVE LIST.

    1. OK : Proceed to next circuit inspection shown on problem symptom table (See  PROBLEM SYMPTOMS TABLE  ). 
    2. NG : Go to next step. 
  2. Check TAIL fuse. 

    CHECK: 

    Check continuity of TAIL fuse.

    OK: 

    Continuity 

    1. NG : Replace the failure fuse. 
    2. OK : Go to next step. 
  3. Check voltage between terminal FTAL and E of front light ECU connector. 

    PREPARATION: 

    1. Turn ignition switch OFF.
    2. Disconnect the front light ECU connector.

    CHECK: 

    Measure voltage between terminal FTAL and E.

    OK: 

    Voltage: 10 - 14 V 

    1. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
    2. NG : Go to next step. 
  4. Check parking light bulb. 
    1. NG : Replace the failure light bulb. 
    2. OK : Go to next step. 
  5. Check wire harness and connector between parking light and front light ECU, battery and parking light (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG : Repair or replace wire harness or connector. 
    2. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ).