LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Front Light (Body No. 5) Control System - Diagnosis) >> Circuit Inspection >> Headlight Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check headlight using LEXUS hand-held tester. 

    PREPARATION: 

    Connect the LEXUS hand-held tester to the DLC3.

    CHECK: 

    Check the headlight using ACTIVE LIST.

    1. OK : Proceed to next circuit Inspection shown on problem symptom table (See  PROBLEM SYMPTOMS TABLE  ). 
    2. NG : Go to next step. 
  2. Check H-IP HS fuse. 

    CHECK: 

    Check continuity of H-LP HI fuse.

    OK: 

    Continuity 

    1. NG : Replace the failure fuse. 
    2. OK : Go to next step. 
  3. Check voltage between terminal FHHI and E of front light ECU connector. 

    PREPARATION: 

    1. Turn the ignition switch OFF.
    2. Disconnect the front Sight ECU connector.

    CHECK: 

    Measure voltage between terminal FHHI and E.

    OK: 

    Voltage: 10 - 14 V 

    1. OK : Proceed to next circuit Inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
    2. NG : Go to next step. 
  4. Check headlight bulb. 
    1. NG : Replace the failure light bulb. 
    2. OK : Go to next step. 
  5. Check wire harness and connector between headlight and front light ECU9 battery and headlight (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG : Repair or replace wire harness or connector. 
    2. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ).