LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Driver Side Junction Block (Body No. 2 Control System) - Diagnosis) >> Circuit Inspection >> Combination Meter Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the combination meter (See  INSPECTION  ). 
    1. NG : Replace the combination meter. 
    2. OK : Go to next step. 
  2. Check wire harness and connector between combination meter and driver side J/B ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG : Repair or replace wire harness or connector. 
    2. OK : Proceed to next circuit inspection shown on problem symptom table (See  PROBLEM SYMPTOMS TABLE  ). 
scientia non olet · About LEMON Manuals