LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Park/Neutral Position (PNP) Switch >> Removal (RX300)

Removal (RX300)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. The PNP switch is located on side of transaxle. Remove splash shield from underneath engine. Disconnect electrical connector at PNP switch. Remove nut from shift control cable and separate cable from shift control lever.
  2. Remove nut, washer and shift control lever. Bend tab upward on lock plate, away from PNP switch retaining nut. Remove PNP switch retaining nut and lock plate. Remove PNP switch retaining bolts and PNP switch.
scientia non olet · About LEMON Manuals