LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Park/Neutral Position (PNP) Switch >> Removal (GS300, IS300, GS430, LS430 & LX470)

Removal (GS300, IS300, GS430, LS430 & LX470)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.

The PNP switch is located on side of transmission. Remove front exhaust pipe, if necessary. Disconnect Park/Neutral Position (PNP) switch connector. Remove control shaft lever. See Figure. Pry off lock washer and remove nut. Remove bolt and PNP switch.