Inspection Procedure

WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC
1. Delete the DTC (See PRE-CHECK ).
2. Insert the key into the ignition key cylinder.
3. Check that no code is output.
  Standard: DTC is not output .
OK: NO PROBLEM

NG: Go to next step.
READ VALUE OF HAND-HELD TESTER
1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch to the ON position, and turn the hand-held tester main switch ON.
3. Select the item "G-CODE DECISION" in the DATA LIST, and read its value displayed on the hand-held tester.
  Standard: G-CODE DECISION: YES or NO
HINT:
- YES indicates that the registration of the ECU communication ID for the ECM and the transponder key ECU has been completed.
- NO indicates that the registration of the ECU communication ID for the ECM and the transponder key ECU has not been completed.
NO: REPLACE KEY

YES: Go to next step.
RE-REGISTER KEY
1. Delete the DTC (See PRE-CHECK ).
2. Re-register the key (See REGISTRATION ), and check that the engine starts with the key.
  Standard: Engine starts.
OK: NORMAL

NG: REPLACE KEY