LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0335 Or DTC P1335: Crankshaft Position (CKP) Sensor Circuit >> Diagnosis & Repair

Diagnosis & Repair

WARNING: This page is about a different car, the 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect CKP sensor harness connector. Using ohmmeter, measure resistance between sensor connector terminals. Resistance should be 1630-2740 ohms at 14-122°F (-10-50°C) or 2065-3225 ohms at 122-212°F (50-100°C). Replace sensor as necessary. If sensor is okay, go to next step.
  2. Check for open or short circuit in wiring harness between ECM and CKP sensor. See WIRING DIAGRAMS article. Repair as necessary. If wiring harness is okay, remove and inspect sensor. Also, inspect signal plate. Replace as necessary. If both components are okay, replace ECM and retest system.
scientia non olet · About LEMON Manuals