LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 348 (Steering System) >> Steering Wheel >> Inspection >> Step 2 - Check Steering Effort

Step 2 - Check Steering Effort

WARNING: This page is about a different car, the 2002 Toyota Prius and 2001 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. Center the steering wheel.
  2. Remove the steering wheel pad. See STEP 1 - REMOVE STEERING WHEEL PAD .
  3. Start the engine and run it at idle.
    4. NOTE: Take the tire type, pressure and contact surface into consideration before making your diagnosis.
    Fig 1: Determining Steering Wheel Effort
    G01066373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. Measure the steering effort in both directions.

    Steering effort (Reference):  6.5 N.m (65 kgf.cm, 58 in.lbf).

  5. Install the steering wheel set nut.

    Torque: 50 N.m (510 kgf.cm, 37 ft.lbf) 

  6. Install the steering wheel pad. See Step 18 - Install Steering Wheel Pad .
scientia non olet · About LEMON Manuals