LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 334 (Anti-Lock Brake System W/EBD & BA & TRAC & VSC System - Diagnostics) >> Circuit Inspection >> Brake Warning Light Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check parking brake switch circuit  . See PARKING BRAKE SWITCH .

    NG:  Repair or replace parking brake switch circuit.

    If OK  , go to step  2.

  2. Check brake fluid level warning switch circuit  . See BRAKE FLUID LEVEL SWITCH .

    NG:  Repair or replace brake fluid level warning switch circuit.

    If OK  , go to step  3.

  3. Is DTC output for ABS? 

    YES:  Repair circuit indicated by the output code.

    If NO  , go to step  4.

  4. Check BRAKE warning light.  See SYSTEM TESTS and TEST NO. 16: BRAKE WARNING LIGHT DOES NOT LIGHT UP .

    NG:  Repair or replace combination meter.

    If OK  , go to step  5.

  5. Check active lamp relay. 

    NG:  Replace active lamp relay.

    If OK  , go to step  6.

  6. Check for open or short circuit in harness and connector between combination meter and active lamp relay.  See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE .

    NG:  Repair or replace harness or connector.

    If OK  , go to step  7.

  7. Check for open or short circuit in harness and connector between active lamp relay and ABS & BA & TRAC & VSC ECU  . See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE .

NG:  Repair or replace harness or connector.

OK:  Check and replace ABS & BA & TRAC & VSC ECU.