Removal & Installation (Land Cruiser, Sequoia & Tundra 4.7L)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft position sensor is located at front of crankshaft, near crankshaft pulley. See Fig 1. Remove lower engine cover for access to crankshaft position sensor. Disconnect electrical connector at crankshaft position sensor. Remove bolt and crankshaft position sensor.
- To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .