Removal & Installation (Tacoma, Tundra 3.4L & 4Runner)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Camshaft position sensor is located behind upper timing belt cover, near passenger's side camshaft sprocket. See Fig 1.
- Drain cooling system. Remove upper radiator hose. Remove necessary components for removal of upper timing belt cover. Remove bolts, upper timing belt cover and gasket. Disconnect electrical connector at camshaft position sensor. Remove bolt and camshaft position sensor.
- To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Fill cooling system.