LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Controls - Removal, Overhaul & Installation V6 & V8) >> Fuel Systems >> Fuel System Pressure Release >> Highlander

Fuel System Pressure Release: Highlander

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove driver's side and passenger's side rear seats and cover plate on floor panel for access to electrical connector for fuel pump. Disconnect electrical connector for fuel pump. This is electrical connector for fuel pump and fuel gauge sending unit. Electric fuel pump is located in the fuel tank.
  2. Start engine and allow engine to idle until engine stalls. Turn ignition off. Reinstall electrical connector for fuel pump, cover plate and rear seats. Disconnect negative battery cable.
  3. Place suitable container under fuel line connection. Cover fuel line connection with shop towel. Slowly loosen or disconnect fuel line connection, allowing fuel pressure to be released. Once fuel pressure is released, fuel system components may be serviced. Reinstall electrical connector for fuel pump and negative battery cable.
scientia non olet · About LEMON Manuals