Removal & Installation (Highlander)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel pressure regulator contains the jet pump assembly and is located on fuel pump assembly in the fuel tank. See Figure. Remove fuel pump from fuel tank. See FUEL PUMP .
- Using screwdriver, release snap fit areas on No. 2 fuel suction support and remove No. 2 fuel suction support from bottom of fuel pump. See Figure. Remove rubber cushion from bottom of fuel pump. Remove fuel pressure regulator with jet pump assembly and "O" ring. Remove "O" ring from fuel pressure regulator with jet pump assembly.
- To install, reverse removal procedure using NEW "O" ring on fuel pressure regulator with jet pump assembly. Coat "O" ring with gasoline before installing fuel pressure regulator with jet pump assembly. Reinstall fuel pump.