Removal & Installation (Tacoma)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle speed sensor is mounted near rear of transmission or transfer case and contains a Black 3-pin electrical connector with Blue, Green/Red and Pink wires. Disconnect electrical connector at vehicle speed sensor. Remove retaining bolt and vehicle speed sensor with "O" ring from transmission or transfer case.
- To install, reverse removal procedure using NEW "O" ring. Coat "O" ring with Dexron-III ATF (A/T models) or gear oil (M/T models) before installing on vehicle speed sensor. Tighten retaining bolt to specification. See TORQUE SPECIFICATIONS .