Removal & Installation (Land Cruiser)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle speed sensor is located on transmission. See Fig 1. Disconnect electrical connector at vehicle speed sensor.
- Remove retaining bolt and vehicle speed sensor with "O" ring from transmission. If necessary to remove drive gear assembly from vehicle speed sensor remove retaining clip from outside of vehicle speed sensor. Retaining clip is located just below "O" ring groove near end of vehicle speed sensor. Remove drive gear from vehicle speed sensor.
- To install, reverse removal procedure using NEW "O" ring. Coat "O" ring with Dexron-III ATF before installing on vehicle speed sensor. Tighten retaining bolt to specification. See TORQUE SPECIFICATIONS .