Removal & Installation (Tacoma, Tundra 3.4L & 4Runner)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Power steering pressure switch is screwed into side of pressure hose at the power steering pump. Disconnect electrical connector at power steering pressure switch. Remove power steering pressure switch.
- To install, reverse removal procedure. Tighten power steering pressure switch to specification. See TORQUE SPECIFICATIONS . Fill power steering pump with Dexron-III ATF.