LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Controls - Removal, Overhaul & Installation V6 & V8) >> Engine Sensors & Switches >> Park/Neutral Position Switch >> Removal (Avalon, Camry, Camry Solara, Highlander & Sienna)

Removal (Avalon, Camry, Camry Solara, Highlander & Sienna)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Park/Neutral Position (PNP) switch is located on side of transaxle. See Figure. Remove necessary components for access to PNP switch.
  2. Disconnect electrical connector at PNP switch. Disconnect shift cable from control lever on transaxle for access to PNP switch.
  3. Remove nut, washer and control lever from transaxle. Bend tabs upward on lock plate, away from PNP switch retaining nut. Remove PNP switch retaining nut, lock plate, PNP switch retaining bolts and PNP switch.
scientia non olet · About LEMON Manuals