Removal & Installation (Land Cruiser & Tundra)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Vapor pressure sensor Vacuum Switching Valve (VSV) servicing procedure is just primarily an unbolt and bolt-on procedure. Vapor pressure sensor is located on charcoal canister. See VAPOR PRESSURE SENSOR VSV LOCATION table. For illustration of vapor pressure sensor VSV location, see EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING - V6 & V8 article.
VAPOR PRESSURE SENSOR VSV LOCATION
| Application | Location | |
|---|---|---|
| Land Cruiser | Mounted On Bracket At Top Center Of Charcoal Canister & Contains Blue 2-Pin Electrical Connector With Blue & Black/Yellow Wires | |
| Tundra | ||
| 3.4L | Mounted On Bracket At Top Center Of Charcoal Canister & Contains Blue 2-Pin Electrical Connector With White/Blue & Gray/Red Wires | |
| 4.7L | Mounted On Bracket At Top Center Of Charcoal Canister & Contains Blue 2-Pin Electrical Connector With Red & Gray/Red Wires | |