Removal & Installation (Land Cruiser, Sequoia, Tacoma, Tundra & 4Runner)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
EVAP VSV servicing procedure is just primarily an unbolt and bolt-on procedure. See EVAP VSV LOCATIONS table. For illustration of EVAP VSV location, see EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING - V6 & V8 article.
EVAP VSV LOCATIONS
| Application | Location | |
|---|---|---|
| Land Cruiser | At Driver's Side Center Of Intake Manifold Below Intake Manifold Cover & Contains Black 2-Pin Electrical Connector With Blue/Black & Black/Yellow Wires | |
| Sequoia | At Driver's Side Center Of Intake Manifold & Contains Black 2-Pin Electrical Connector With Green/Red & White/Green Wires | |
| Tacoma | On Bracket Bolted To Inside Of Driver's Side Front Fender Panel & Contains Black 2-Pin Electrical Connector With White/Red & White/Green Wires | |
| Tundra | ||
| 3.4L | At Driver's Side Rear Corner Of Air Intake Chamber & Contains Black 2-Pin Electrical Connector With White/Blue & White/Green Wires | |
| 4.7L | At Driver's Side Center Of Intake Manifold & Contains Black 2-Pin Electrical Connector With Red & White/Green Wires | |
| 4Runner | On Bracket Bolted To Inside Of Driver's Side Front Fender Panel & Contains Black 2-Pin Electrical Connector With White/Blue & White/Green Wires | |