Removal & Installation
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Ensure ignition is off. Remove Engine Control Module (ECM). See ECM LOCATION table. To install, reverse removal procedure.
ECM LOCATION
| Model | (1) Location | ||
|---|---|---|---|
| Avalon | Behind Glove Box, Near Passenger's Side Kick Panel | ||
| Camry, Camry Solara & Highlander | Behind Glove Box | ||
| Land Cruiser | Above Glove Box, Near Passenger's Side Of Instrument Panel | ||
| Sequoia | Behind Glove Box & Heater Duct | ||
| Sienna | Passenger's Side Of Instrument Panel, Just Below Glove Box | ||
| Tacoma & 4Runner | Behind Glove Box | ||
| Tundra | Behind Glove Box & Heater Duct | ||
|
|||