Removal & Installation (Avalon, Highlander & Sienna)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Remove "V" bank cover. See Fig 1 and Fig 2 . Acoustic Control Induction System (ACIS) Vacuum Switching Valve (VSV) No. 1 and 2 are located on emission control valve set. See Fig 1 and Fig 2 . ACIS VSV No. 1 is used for intake air control valve near throttle bodies which may be referred to as No. 1 intake air control valve. ACIS VSV No. 1 may also be referred to as intake air control valve No. 1 VSV. ACIS VSV No. 2 is used for intake air control valve on end of air intake chamber which may be referred to as No. 2 intake air control valve. ACIS VSV No. 2 may also be referred to as intake air control valve No. 2 VSV.
- Disconnect electrical connectors and vacuum lines from vacuum switching valves on emission control valve set. Remove emission control valve set.
- Remove appropriate ACIS VSV from emission control valve set. To install, reverse removal procedure.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002