LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Variable Valve Lift System >> Variable Valve Lift Oil Control Valve >> Removal & Installation (Celica 1.8L 2ZZ-GE)

Removal & Installation (Celica 1.8L 2ZZ-GE)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Variable Valve Lift (VVL) oil control valve is located at intake manifold side of cylinder head, near flywheel end of engine. See Figure. Remove No. 2 cylinder head cover located on top of engine, above ignition coils and valve cover, front fender apron seal and upper radiator support seal. See Figure.
  2. Disconnect electrical connector at VVL oil control valve. Remove retaining bolt and VVL oil control valve with "O" ring from housing on rear of cylinder head. To install, reverse removal procedure using NEW "O" ring. Tighten retaining bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals