LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Ignition Systems >> Ignition Coil >> Removal & Installation (MR2)

Removal & Installation (MR2)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove suspension upper brace. Suspension upper brace fits between strut towers and is bolted to top of each strut tower. Remove No. 2 cylinder head cover located on top of engine, above ignition coils for access to ignition coil. Disconnect electrical connector at ignition coil mounted on valve cover.
  2. Note location of ignition coil for installation reference. Remove ignition coil bolt, ignition coil and dust seal from valve cover.
  3. To install, reverse removal procedure. Tighten ignition coil bolt and suspension upper brace bolt/nut to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals