Removal & Installation (MR2)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft position sensor is located on front of engine, near crankshaft pulley. See Figure. Raise and support vehicle. Remove lower engine cover. A/C compressor must be removed for access to crankshaft position sensor.
- Rotate automatic belt tensioner clockwise as viewed from front of engine to release tension from accessory drive belt. Remove accessory drive belt. Remove bolts and A/C compressor with hoses attached for access to crankshaft position sensor. Disconnect electrical connector for crankshaft position sensor. Remove bolt and crankshaft position sensor with "O" ring.
- To install, reverse removal procedure using NEW "O" ring. Tighten crankshaft position sensor bolt and A/C compressor bolts to specification. See TORQUE SPECIFICATIONS .