Crankshaft Position Sensor: Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

Install crankshaft position sensor. Install and tighten crankshaft position sensor bolts to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure using NEW gaskets.
On 1.8L 2ZZ-GE models, note intake manifold bolt/nut identification before tightening intake manifold bolts/nuts to specification. See Figure. On all models, ensure gasket for throttle body is installed with protrusion area facing proper direction. See THROTTLE BODY under FUEL SYSTEMS. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS . Fill and bleed cooling system. See COOLING SYSTEM BLEEDING under COOLING SYSTEM.

Fig 1: Locating Typical Crankshaft Position Sensor (Celica, Corolla, MR2 & RAV4)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install crankshaft position sensor. Install and tighten crankshaft position sensor bolts to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure using NEW gaskets. Ensure gasket for throttle body is installed with protrusion area facing proper direction. See THROTTLE BODY under FUEL SYSTEMS. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS . Fill cooling system.