LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Fuel Systems >> Throttle Body >> Removal & Installation (Tacoma)

Removal & Installation (Tacoma)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system. Remove air cleaner hose and intake air connector. See Figure.
  2. Disconnect control cable(s), PCV hose, air hose, vacuum hoses and electrical connectors at throttle body. Remove bolts/nuts, throttle body and gasket from intake manifold. Disconnect remaining coolant hoses from bottom of throttle body. Remove throttle body. Remove screws, Idle Air Control (IAC) valve and gasket from bottom of throttle body (if necessary).
  3. To install, reverse removal procedure using NEW gasket. Tighten throttle body bolts/nuts to specification. See TORQUE SPECIFICATIONS . Fill cooling system
scientia non olet · About LEMON Manuals