LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Fuel Systems >> Fuel Rails & Fuel Injectors >> Removal (Tacoma)

Removal (Tacoma)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove air cleaner hose and intake air connector for access to fuel rail and fuel injectors. See Figure.
  2. Note location of electrical connectors on fuel injectors for installation reference. Disconnect electrical connectors at fuel injectors. Disconnect air hose and fuel return hose from fuel pressure regulator.
  3. Remove union bolt with gaskets and disconnect fuel inlet pipe from fuel rail. See Figure.
    4. CAUTION: When removing fuel rail, use care not to allow fuel injectors to fall from fuel rail.
  4. Remove fuel rail-to-cylinder head bolts. Remove fuel rail with fuel injectors. Remove 4 insulators from spacers on cylinder head. See Figure. Remove fuel injectors from fuel rail. Remove "O" ring and grommet (except Calif. emission vehicles only) from fuel injector. See Figure.
scientia non olet · About LEMON Manuals