LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Fuel Systems >> Fuel Rails & Fuel Injectors >> Removal (ECHO)

Removal (ECHO)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove No. 2 cylinder head cover located on top of engine, above ignition coils and valve cover, ignition coils, valve cover and gasket. See Figure.
  2. Remove fuel pipe clamp from end of fuel pipe at end of fuel rail. Perform STEP 1 in illustration. See Figure. Ensure area around fuel pipe and disconnect fitting is clean.
    3. CAUTION: Use care when disconnecting fuel pipe, as some residual fuel pressure may still exist in the fuel system.
  3. Depress both sides of retainer and pull fuel pipe with disconnect fitting from fuel pipe fitting. Perform STEP 2 in illustration. See Figure. Note location of electrical connectors on fuel injectors for installation reference. Disconnect electrical connectors at fuel injectors.
    4. CAUTION: When removing fuel rail, use care not to allow fuel injectors to fall from fuel rail.
  4. Remove bolt from fuel pipe clamp at the cylinder head. See Figure. Remove fuel rail-to-cylinder head bolts. Remove fuel rail with fuel injectors as an assembly. Remove the 2 spacers from cylinder head. Remove fuel injectors from fuel rail. Remove "O" ring and grommet from fuel injector.
scientia non olet · About LEMON Manuals