LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Fuel Systems >> Fuel Pump >> Removal (Prius)

Removal (Prius)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS .
  1. It may be necessary to replace fuel pump and fuel tank as an assembly. Consult local parts department for parts availability. To remove fuel tank, release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Remove rear seat cushion and cover plate on floor panel for access to fuel pump if not previously done. Disconnect electrical connector from top of fuel pump. This is electrical connector for fuel pump and fuel gauge sending unit. Electric fuel pump is located in the fuel tank.
  3. Raise and support vehicle. Remove exhaust pipe assembly and tailpipe for access to fuel tank. Drain gasoline from fuel tank into approved container. Disconnect fuel filler tube and any remaining hoses for fuel tank removal. Support fuel tank with transmission jack. Remove fuel tank retaining bolts and fuel tank.