Removal & Installation (Camry, Camry Solara, Celica, Highlander & RAV4)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Power steering pressure switch is screwed into side of power steering pump, near pressure hose fitting. It may be necessary to remove power steering pump for access to power steering pressure switch. Disconnect electrical connector at power steering pressure switch. Remove power steering pressure switch with "O" ring (if equipped) from power steering pump.
- To install, reverse removal procedure using NEW "O" ring (if equipped). Coat "O" ring with Dexron-III ATF before installing power steering pressure switch. Tighten power steering pressure switch to specification. See TORQUE SPECIFICATIONS . Fill power steering pump with Dexron-III ATF.