Removal & Installation (ECHO)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Power steering pressure sensor is located on side of power steering pump and contains a 3-pin electrical connector. Disconnect electrical connector at power steering pressure sensor. Remove power steering pressure sensor with "O" ring from power steering pump.
- To install, reverse removal procedure using NEW "O" ring. Coat "O" ring with Dexron-III ATF before installing power steering pressure sensor. Tighten power steering pressure sensor to specification. See TORQUE SPECIFICATIONS . Fill power steering pump with Dexron-III ATF.