LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Engine Sensors & Switches >> Park/Neutral Position Switch >> Removal (Tacoma)

Removal (Tacoma)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Park/Neutral Position (PNP) switch is located on side of transmission. See Figure. Remove front exhaust pipe with heat insulator (if necessary) and disconnect transmission oil cooler line for access to PNP switch.
  2. Remove transmission oil cooler line elbow with "O" ring for access to PNP switch (if necessary). Disconnect electrical connector at PNP switch.
  3. Bend tabs upward on lock plate, away from PNP switch retaining nut. Remove PNP switch retaining nut, lock plate, PNP switch retaining bolt and PNP switch.
scientia non olet · About LEMON Manuals