Removal (RAV4)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Knock sensor is located on side of cylinder block. See Figure. Manufacturer states to remove engine and transaxle for access to knock sensor. See appropriate article in ENGINES.
- Disconnect necessary hoses, electrical connectors and engine wiring harness for removal of intake manifold with throttle body. Remove bolts/nuts, intake manifold with throttle body, gasket and intake manifold insulator. Using Socket (SST 09816-30010), remove knock sensor from cylinder block.