Removal & Installation (Tacoma)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Remove starter and fuel filter mounting bolts to access knock sensor. Knock sensor is located on side of cylinder block. See Fig 1.
- Disconnect electrical connector at knock sensor. Using Socket (SST 09816-30010), remove knock sensor from cylinder block.
- To install, reverse removal procedure. Tighten knock sensor, fuel filter mounting bolts and starter bolts to specification. See TORQUE SPECIFICATIONS .