LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Engine Sensors & Switches >> Ignition Switch >> Removal & Installation (All Models)

Removal & Installation (All Models)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

Ignition switch is located at bottom of upper steering column bracket. See Fig 1. If necessary to remove steering column for access to ignition switch, see appropriate STEERING COLUMN OVERHAUL information in appropriate STEERING COLUMNS article. Remove screws and ignition switch. To install, reverse removal procedure.

Fig 1: Locating Typical Ignition Switch
G00035201Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002