LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Engine Sensors & Switches >> EGR Gas Temperature Sensor >> Removal & Installation (Tacoma 2.7L 4-Cyl. 3RZ-FE)

Removal & Installation (Tacoma 2.7L 4-Cyl. 3RZ-FE)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect electrical connector at EGR gas temperature sensor. EGR gas temperature sensor is located near EGR valve. See Fig 1.
  2. It may be necessary to remove EGR valve for access to EGR gas temperature sensor. See EGR VALVE  under EMISSION SYSTEMS & SUB-SYSTEMS. Remove EGR gas temperature sensor. To install, reverse removal procedure.
    Fig 1: Locating EGR Gas Temperature Sensor (Tacoma 2.7L 4-Cyl. 3RZ-FE)
    G99D08724Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002