LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Engine Sensors & Switches >> BRAKELIGHT Switch >> Removal & Installation (Camry)

Removal & Installation (Camry)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove necessary components for access to brakelight switch. Brakelight switch is located near top of brake pedal. Disconnect electrical connector at brakelight switch. Loosen lock nut on brakelight switch. Remove brakelight switch from mounting bracket.
  2. Install brakelight switch in mounting bracket. Install electrical connector on brakelight switch. Depress brake pedal.20-.39" (5.0-10.0 mm) and hold in this position. Rotate brakelight switch inward until stoplights go off. Tighten lock nut. Release brake pedal.
  3. Depress brake pedal.20-.39" (5.0-10.0 mm) and ensure brakelights come on. Release brake pedal. Ensure brakelights go off.
scientia non olet · About LEMON Manuals