Removal (Prius)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS .
- Vapor pressure sensor is located at top corner of fuel tank. See Figure. Manufacturer states fuel tank must be removed for access to vapor pressure sensor. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
- Remove rear seat cushion and cover plate on floor panel for access to fuel pump if not previously done. Disconnect electrical connector from top of fuel pump. This is electrical connector for fuel pump and fuel gauge sending unit. Electric fuel pump is located in the fuel tank.
- Raise and support vehicle. Remove exhaust pipe assembly and tailpipe for access to fuel tank. Drain gasoline from fuel tank into approved container. Disconnect fuel filler tube and any remaining hoses for fuel tank removal. Support fuel tank with transmission jack. Remove fuel tank retaining bolts and fuel tank.
- Disconnect electrical connector at vapor pressure sensor. Ensure area around vapor pressure sensor is clean. Remove retaining clip and vapor pressure sensor from mounting flange. Use care not to scratch vapor pressure sensor or vapor pressure sensor sealing surfaces. DO NOT use tools to remove vapor pressure sensor. Vapor pressure sensor should be removed from mounting flange by-hand.