Removal & Installation (Celica & ECHO)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
Vapor pressure sensor is located on top of fuel pump. See Figure and Figure . Remove rear seat cushion and cover plate on floor panel for access to vapor pressure sensor. Disconnect electrical connector at vapor pressure sensor. Ensure area around vapor pressure sensor is clean. Remove retaining clip and vapor pressure sensor. To install reverse removal procedure.