LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Emission Systems & Sub-Systems >> Canister Closed Valve Vacuum Switching Valve >> Installation

Canister Closed Valve Vacuum Switching Valve: Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure using NEW seal packing on trap filter and gasket on exhaust pipe at exhaust manifold. Tighten fuel tank retaining bolts and exhaust pipe-to-exhaust manifold bolts to specification. See TORQUE SPECIFICATIONS . Operate fuel pump and check for fuel leaks. See FUEL PUMP OPERATION under FUEL SYSTEMS in BASIC DIAGNOSTIC PROCEDURES - 4-CYLINDER article.

Fig 1: Locating Canister Closed Valve Vacuum Switching Valve, Fresh Air Valve & Trap Filter (Prius)
G00015556Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002