LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Controls - System & Component Testing - V6 & V8) >> Modules, Motors, Relays & Solenoids >> Fuel Pump Relay >> Sequoia & Tundra 4.7L V8

Sequoia & Tundra 4.7L V8

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off. Remove fuel pump relay from fuse/relay box at driver's side front corner of engine compartment. See Figure and Figure .
  2. To test fuel pump relay continuity, using ohmmeter, check for continuity and no continuity between specified terminals on fuel pump relay. See Fig 1.
  3. To test fuel pump relay operation, apply battery voltage and ground to fuel pump relay and use ohmmeter to check for continuity between specified terminals on fuel pump relay. See Fig 1. Replace fuel pump relay if defective.
    Fig 1: Testing Fuel Pump Relay (Sequoia & Tundra 4.7L V8)
    G99J08741Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002