LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Controls - System & Component Testing - V6 & V8) >> Fuel Systems >> Fuel Delivery >> Fuel Pump Switch (Land Cruiser)

Fuel Pump Switch (Land Cruiser)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Fuel pump switch may also be referred to as fuel pump inertia switch or fuel pump control switch.
  1. Fuel pump switch is located on driver's side of instrument panel and contains a reset switch. See Fig 1. Disconnect electrical connector at fuel pump switch. It may be necessary to remove carpet and fuel pump switch for access to electrical connector.
  2. Using ohmmeter, check that no continuity exists between electrical terminals on fuel pump switch with reset switch in OFF position. Check that continuity exists between electrical terminals on fuel pump switch with reset switch in ON position. Replace fuel pump switch if defective. Ensure reset switch is in the ON position for fuel pump operation.
    Fig 1: Locating Fuel Pump Switch & Identifying Reset Switch Positions (Land Cruiser)
    G98J01612Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002