Heated Oxygen Sensor: Camry
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- A heated A/F sensor is mounted on exhaust manifold above catalytic converter. For testing of A/F sensor, see AIR/FUEL SENSOR . Another heated oxygen sensor is mounted on exhaust pipe after catalytic converter. This heated oxygen sensor is referred to as bank No. 1 sensor No. 2.
- To test heater resistance on heated oxygen sensor, disconnect electrical connector for heated oxygen sensor. Using ohmmeter, check resistance between +B and HT terminals on electrical connector. See Fig 1. Replace heated oxygen sensor if resistance is not 11-16 ohms at 68°F (20°C). See HEATED OXYGEN SENSOR under ENGINE SENSORS & SWITCHES in REMOVAL, OVERHAUL & INSTALLATION - 4-CYLINDER article.
- To check that heater is not shorted, using ohmmeter, check that no continuity exists between E1 and HT terminals on electrical connector. See Fig 1. Replace heated oxygen sensor if continuity exists. See HEATED OXYGEN SENSOR under ENGINE SENSORS & SWITCHES in REMOVAL, OVERHAUL & INSTALLATION - 4-CYLINDER article.
- If problem exists in heated oxygen sensor, heater or wiring circuit, a Diagnostic Trouble Code (DTC) may be stored in Engine Control Module (ECM). See TESTING PROCEDURE under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article for retrieving of DTCs.