Inspection Procedure
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Check Tire Size.
- NG : Replace tires so that all 4 tires are the same in size.
- OK : Go to step 2.
- Check Speed Sensor
. See DTC C0200/31-C0215/34 SPEED SENSOR CIRCUIT .
- NG : Replace speed sensor.
- OK : Check and replace skid control ECU.
NOTE: When replacing the ECU, perform the zero point calibration. See step 6 under PRE-CHECK.