LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Abs - Diagnostics) >> Diagnostic Tests >> DTC C1310/11: Active Brake Booster Solenoid Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check Active Brake Booster Solenoid. 

    PREPARATION  : disconnect the connector from brake booster.

    Check  : Resistance between terminals 3 and 4 of brake booster. See Fig 1.

    OK  : Resistance: 1.1-1.7 ohms

    Fig 1: Identifying Brake Booster Terminals
    G01118789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG  : Replace brake booster.
    2. OK  : Go to step  2.
  2. Check for open and short circuit in harness and connector between skid control ECU and brake booster. See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE .
    1. NG  : Repair or replace harness or connector.
      2. NOTE: When replacing the ECU, perform the zero point calibration. See step  6 under PRE-CHECK.
    2. OK  : Check and replace skid control ECU.
scientia non olet · About LEMON Manuals