Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

Check DTC once more .

Preparation :
1. Clear the DTC. See step 1) e or f under PRE-CHECK.
2. Turn the ignition switch OFF.
Check : turn the ignition switch ON, and check that the same DTC is stored in the memory.
NO : No problem.

YES : Check and replace skid control ECU.

NOTE: When replacing the ECU, perform the zero point calibration. See step 6 under PRE-CHECK.