Shock Absorber Assembly: Inspection
WARNING: This page is about a different car, the 2004 Toyota Avalon, 2003 Toyota Avalon, and 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To prevent personal injury, discharge gas from old shock absorber prior to disposal. Carefully drill a hole 0.08-0.12 in. (2-3 mm) in diameter above lower mounting bracket on cylinder.
Compress and extend shock/strut shaft to check for abnormal resistance or noise. Push shaft in fully, and release. Shaft should return at a constant speed throughout its travel. If shock/strut is defective, replace as an assembly.