LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Axle Shafts) >> Removal & Installation >> AVALON >> Installation

Removal & Installation: AVALON: Installation

WARNING: This page is about a different car, the 2004 Toyota Avalon, 2003 Toyota Avalon, and 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure drive shaft standard length. See Figure and See AXLE SHAFT LENGTH SPECIFICATIONS  table.
  2. To install, reverse removal procedure. Coat gear oil to inboard joint shaft and differential case sliding surface. Before installing axle shaft, set snap ring opening side facing downward. Check if inboard joint shaft is making contact with pinion shaft can be felt from sound and feeling when driving vehicle. Install axle shafts into wheel hub. Align suspension marks made at removal, and tighten nuts to specifications. See TORQUE SPECIFICATIONS .
  3. After installation, check that there is 0.08-.12 in. (2.0-3.0 mm) of play in axial direction and that axle shaft can not be removed by hand.
scientia non olet · About LEMON Manuals