LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Driver-side & Passenger-side AIR Bag Modules

Driver-side & Passenger-side AIR Bag Modules

WARNING: This page is about a different car, the 2003 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Ensure steering wheel, driver-side air bag module and passenger-side air bag are not loose. If components are loose, deploy air bag(s) using OFF-VEHICLE DEPLOYMENT  procedure.
  2. If deploying driver-side air bag module, disconnect spiral cable connector, accessible by removal of lower steering column cover. If deploying passenger-side air bag module, disconnect passenger-side air bag connector, accessible through glove box opening. See Figure. For either air bag, connect Deployment Tool (09082-00700 and 09082-00760) connector to air bag module connector. Position deployment tool at least 33 feet (10 m) from front of vehicle.
  3. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Ensure no one is inside vehicle or within 33 feet (10 m) of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
scientia non olet · About LEMON Manuals